Ashcroft 205 - Diaphragm Seal Uživatelský manuál stáhnout pdf

The 105/205 Saddle Seal is welded to the wall of a pipe as follows:

1.) A hole of the following diameter must be drilled in the pipe:

• For a 3˝ diameter pipe drill a 2

⁄

8˝ diameter hole.

• For a 4˝ diameter hole and larger pipe drill a 3˝ diameter hole.

2.) Remove upper housing of the seal from the lower housing

by removing (8) bolts. Use care so as not to damage the .004˝

thick diaphragm and Teflon gasket.

3.) Weld lower housing to the pipe as specified by the piping engineer.

Note: Excess heat from welding could distort the sealing surface

inside the lower housing. It is recommended a wet rag or

metal sink be placed against the sealing surface inside the

lower housing.

4.) Reassemble the top housing to the lower housing using the (8)

bolts removed in Step 2.

Note: Using a uniform cross tightening procedure, initially tighten

bolts finger tight, then 3 ft-lbs,

6 ft-lbs, and a final torque of 10 to 13 ft-lbs.

5.) A leak test of the piping system is recommended after assembly.

Tel: 203-378-8281 • www.ashcroft.com

All sales subject to standard terms and conditions of sale. I&M008-10183 6/10

Type 105/205 Saddle Seal

Installation Procedure

Shrnutí obsahu

Strany 1 - Installation Procedure

The 105/205 Saddle Seal is welded to the wall of a pipe as follows:1.) A hole of the following diameter must be drilled in the pipe:• For a 3˝ diamete

Příbuzné modely 105 - Diaphragm Seal

Komentáře k této Příručce

Žádné komentáře

Ashcroft 205 - Diaphragm Seal Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Měřící nástroje Ashcroft 205 - Diaphragm Seal. Ashcroft 205 - Diaphragm Seal User Manual [fr] Uživatelská příručka

Shrnutí obsahu

Příbuzné modely 105 - Diaphragm Seal

Komentáře k této Příručce

Související produkty a manuály pro Měřící nástroje Ashcroft 205 - Diaphragm Seal